当前位置:龙人芯片解密公司 >> IC芯片解密 >> CY7C63813-SXC芯片的解密特性与运用

CY7C63813-SXC芯片的解密特性与运用

  作为深圳最具实力的芯片解密、IC解密、单片机解密等解密服务的深圳龙人科技有限公司拥有多年的解密服务经验和超高水平的解密技术,一直从客户利益出发,为每位客户提供最科学最合理最低成本的解密方案与解密服务,深受客户的信赖与喜爱。下面给大家介绍下CY7C63813-SXC芯片的解密特性与运用,仅供参考。
  Features
  · USB 2.0-USB-IF certified (TID # 40000085)
  · enCoReTMII USB - “enhanced Component Reduction”
    - Crystalless oscillator with support for an external clock. The internal oscillator eliminates the need for an external crystal or resonator.
    - Two internal 3.3V regulators and an internal USB pull up resistor
    - Configurable IO for real world interface without external components
  · USB Specification Compliance
    - Conforms to USB Specification, Version 2.0
    - Conforms to USB HID Specification, Version 1.1
    - Supports one Low-Speed USB device address
    - Supports one control endpoint and two data endpoints
    - Integrated USB transceiver with dedicated 3.3V regulator for USB signalling and D– pull up.
  · Enhanced 8-bit microcontroller
    - Harvard architecture
    - M8C CPU speed is up to 24 MHz or sourced by an external clock signal
  · Internal memory
    - Up to 256 bytes of RAM
    - Up to eight Kbytes of Flash including EEROM emulation
  · Interface can auto configure to operate as PS/2 or USB
    - No external components for switching between PS/2 and USB modes
    - No General Purpose IO (GPIO) pins needed to manage dual mode capability
  · Low power consumption
    - Typically 10 mA at 6 MHz
    - 10 μA sleep
  · In system reprogrammability:
    - Allows easy firmware update
  · GPIO ports
    - Up to 20 GPIO pins
    - 2mA source current on all GPIO pins. Configurable 8 or 50 mA/pin current sink on designated pins.
    - Each GPIO port supports high impedance inputs, configurable pull up, open drain output, CMOS/TTL inputs, and CMOS output
    - Maskable interrupts on all IO pins
  · A dedicated 3.3V regulator for the USB PHY. Aids in signalling and D– line pull up
  · 125 mA 3.3V voltage regulator powers external 3.3V devices
  · 3.3V IO pins
    - 4 IO pins with 3.3V logic levels
    - Each 3.3V pin supports high impedance input, internal pull up, open drain output or traditional CMOS output
  · SPI serial communication
    - Master or slave operation
    - Configurable up to 4 Mbit/second transfers in the master mode
    - Supports half duplex single data line mode for optical sensors
  · 2-channel 8-bit or 1-channel 16-bit capture timer registers.Capture timer registers store both rising and falling edge times.
    - Two registers each for two input pins
    - Separate registers for rising and falling edge capture
    - Simplifies the interface to RF inputs for wireless applications
  · Internal low power wakeup timer during suspend mode:
    - Periodic wakeup with no external components
  · 12-bit Programmable Interval Timer with interrupts
  · Advanced development tools based on Cypress MicroSystems PSoC- tools
  · Watchdog timer (WDT)
  · Low voltage detection with user configurable threshold voltages
  · Operating voltage from 4.0V to 5.5VDC
  · Operating temperature from 0–70°C
  · Available in 16 and 18-pin PDIP; 16, 18, and 24-pin SOIC;24-pin QSOP, and 32-pin QFN packages
  · Industry standard programmer support
  
  Applications
  The CY7C63310/CY7C638xx is targeted for the following applications:
  · PC HID devices
    - Mice (optomechanical, optical, trackball)
  · Gaming
    - Joysticks
    - Game pad
  · General purpose
    - Barcode scanners
    - POS terminal
    - Consumer electronics
    - Toys
    - Remote controls
    - Security dongles
    如有CY7C63813-SXC芯片的解密需求敬请访问咨询http://www.xpjm.net